MakerWorld
Hueforge & Lithophane
Model downloaden
Pit
8
Downloads
17
Likes
4
Makes
The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mmFilaments Used:PLA PolyLite Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA PolyLite Grey Transmission Distance: 1PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Red Transmission Distance: 4This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #7 (0.64mm) swap to Blue GrayAt layer #10 (0.88mm) swap to GreyAt layer #16 (1.36mm) swap to Jade WhiteAt layer #17 (1.44mm) swap to Red for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!
Corp publiceert ook op
338 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
