Thingiverse
Pitcheron LIDL conversion
von adinko
22
Downloads
40
Likes
0
Makes
This is my take on pitcheron conversion for LIDL glider.
Print L and R Body from LW-PLA to save some weight.
Wing holds should be printed from PLA because of wear.
Video here: https://youtu.be/2k3SOsBdpps
[EDIT 2024-08-14] I've added version thah houses MG90S servos from Amazon. At the same time that version should be easier to print and has extended hole to accommodate servo cable.
Parts here:
- MG90S servos from AZDelivery (5pcs set) ~ 25 Euro - https://amzn.to/3YHabOY
- M3 screws (440pcs set) ~10 Euro - https://amzn.to/4e0rD5F
- M3 brass inserts (100pcs) ~ 7 Euro - https://amzn.to/3WRXtuq
- 1.3mm servo push rods (10pcs) ~ 7Euro - https://amzn.to/3yCGTXb
Print L and R Body from LW-PLA to save some weight.
Wing holds should be printed from PLA because of wear.
Video here: https://youtu.be/2k3SOsBdpps
[EDIT 2024-08-14] I've added version thah houses MG90S servos from Amazon. At the same time that version should be easier to print and has extended hole to accommodate servo cable.
Parts here:
- MG90S servos from AZDelivery (5pcs set) ~ 25 Euro - https://amzn.to/3YHabOY
- M3 screws (440pcs set) ~10 Euro - https://amzn.to/4e0rD5F
- M3 brass inserts (100pcs) ~ 7 Euro - https://amzn.to/3WRXtuq
- 1.3mm servo push rods (10pcs) ~ 7Euro - https://amzn.to/3yCGTXb
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
