Thingiverse
Pla model Nipper cap
von Oxitocin
95
Downloads
65
Likes
2
Makes
[ Nipper ]
-Tamiya : Side cutter series
-Godhand : Ultimate Nipper Ver.5.0 [GH-SPN-120]
-3Peaks : MK-02
*following dimensions can be used.
-6mm x 11mm x 32mm (T x W x L)
*Safety!
*easy!
Note:
If it's too tight, put it on the Hotbad for 30 minutes with the cap on.
-Tamiya : Side cutter series
-Godhand : Ultimate Nipper Ver.5.0 [GH-SPN-120]
-3Peaks : MK-02
*following dimensions can be used.
-6mm x 11mm x 32mm (T x W x L)
*Safety!
*easy!
Note:
If it's too tight, put it on the Hotbad for 30 minutes with the cap on.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
