Thingiverse
PLA Spool Centres
von vik
20
Downloads
20
Likes
2
Makes
This is a 100mm centre for the spool that Diamond Age Solutions supply their 500m spools of 3mm and 1.8mm PLA, and 1.75mm ABS on. Each centre takes a 608 bearing, and a piece of M8 rod goes through the middle. A set of locknuts on each side keeps the centres in place.
The file is parametric so you can change diameters to suit.
The file is parametric so you can change diameters to suit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
