Thingiverse
PLA Test Tower
von rogbigras
82
Downloads
42
Likes
0
Makes
if you have a slice that can adjust the temperatures, this thing can help you decide what is the best temperature to print at.
Every 6MM height you lower the temp by 5 degrees
Start your temperature at 210.
Every 6MM height you lower the temp by 5 degrees
Start your temperature at 210.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!