Thingiverse
Plastic Knuckles
von Bocnov
93
Downloads
67
Likes
0
Makes
I have designed these "brass" knuckles with FreeCAD and I am pretty satisfied with the results, since I still am pretty new in the 3D printing universe.
80% or higher infill is recommended in order to obtain a print dense enough.
Also, the size depends on how big your hands are. In my case it was 90% the original size, which I strongly recommend.
IMPORTANT: This is intended to be used only as a self defense weapon in an extreme emergency case. Do not use it to harm anyone, as it could cause serious injuries.
80% or higher infill is recommended in order to obtain a print dense enough.
Also, the size depends on how big your hands are. In my case it was 90% the original size, which I strongly recommend.
IMPORTANT: This is intended to be used only as a self defense weapon in an extreme emergency case. Do not use it to harm anyone, as it could cause serious injuries.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
