Playseat Trophy Riser

I have Playseat Trophy and had to rise back of it around 10cm to get a good seating position aligned with my monitor.

I designed this riser for myself and hope it will work for somebody else who is in the same need. I have put only to backside but feel free to print it 4 times and use it at all 4 corners. I have put some Felt Pads to bottom of design not to scratch my surface. I have also used same felt pats to contact point with metal tube. Lastly, I zip-tied this leg and seat together.

35% Infill worked fine with regular PLA.