Pliers Multitool

Fully 3D printable pliers-style multitool styled after the Leatherman Charge Plus (https://www.leatherman.com/charge-552.html)
No screws or springs required, some filament is used for hinges. Assemble the Pliers LAST for an easier time.

All the tools are printed with the hole axes vertical, on the flattest side. Only the Pliers print with supports and infill. All other parts print without supports and with only top and bottom layers. The Latches print on their flattest side. Half Pins and Half Rivets print on the flat faces. Everything prints at 0.2mm layer height. The Clearance Test lets you judge if your printer can handle the clearances. Elephant's foot is a big problem for this design.

The Frame is a fold-up part, refer to the image for help on folding it properly. It may take a few attempts, be prepared to print extra. I recommend folding from the middle outward for the easiest experience. Have a pair of pliers handy to hold onto the thin flanges when bending. Do not print