Thingiverse
Plinking Spinner Target
von RBless614
41
Downloads
27
Likes
0
Makes
https://youtu.be/FgvKmA3bWag
https://youtu.be/eF2V_fm207s
UPDATE - 8/6/2021 - Holes enlarged for easier assembly. Giggity.
This is a Spinning / Self-Resetting Plinking Target. I had some left over rods and bearings from a Spool Holder that I printed from someone's thingiverse. So I decided to find a way to put the extra parts to good use. I had previously attempted to make something like this by hand and without a bearing, but it wasn't nearly as nice. This has been printed, tested, then tweaked to perfection.
The Rod holder mount can be used to mount to just about anything that a screw can tap. I have a large chain-link fence at the back of my yard with a rounded cap on it. So I also created a cover that I can mount the rod holder on to. I have not tested that part yet, but if you check the video and pictures, you can see I've tested this by mounting to a tree.
I printed this using:
Ender 3 Pro - SKR v1.4Turbo - TCM2209 x 5 - Dual Z Axis - BIQU H2 Extruder- BLTouch v1.
https://youtu.be/eF2V_fm207s
UPDATE - 8/6/2021 - Holes enlarged for easier assembly. Giggity.
This is a Spinning / Self-Resetting Plinking Target. I had some left over rods and bearings from a Spool Holder that I printed from someone's thingiverse. So I decided to find a way to put the extra parts to good use. I had previously attempted to make something like this by hand and without a bearing, but it wasn't nearly as nice. This has been printed, tested, then tweaked to perfection.
The Rod holder mount can be used to mount to just about anything that a screw can tap. I have a large chain-link fence at the back of my yard with a rounded cap on it. So I also created a cover that I can mount the rod holder on to. I have not tested that part yet, but if you check the video and pictures, you can see I've tested this by mounting to a tree.
I printed this using:
Ender 3 Pro - SKR v1.4Turbo - TCM2209 x 5 - Dual Z Axis - BIQU H2 Extruder- BLTouch v1.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!