Thingiverse
Plotter Paper Holder
0
Downloads
0
Likes
0
Makes
Little snap on piece for the plotter at work. Do not know what kind it is or what mechanisms are typical of plotters to know how universal it is. Hopefully it will work for you! Printed in PLA Plus and 3 walls, we had problems with regular PLA but again I can't remember how it was breaking.
Regardless I made a few of them at once with 45% infill, 3 walls, tilted it vertically by 10% with a raft and supports, haven't had to replace one since the material and orientation change.
Regardless I made a few of them at once with 45% infill, 3 walls, tilted it vertically by 10% with a raft and supports, haven't had to replace one since the material and orientation change.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
