Thingiverse
PLTW Train
von blucky
0
Downloads
1
Likes
0
Makes
3D Printing this train for my PLTW class.
Print one of each part, except you will need 4 wheels, 4 axle pegs, 4 linkage pegs, and 2 linkage arms. A windshield is not needed. I would advise not printing the hitch peg and hitch magnet--if you do print them, print the hitch magnet slightly larger, and the hitch peg slightly smaller.
*If printing an overall 75% scale model*:
Print axle pegs @ 90%
Print linkage pegs @ 60%
Print cow catcher @ 95%
Print everything else @ 75%
Print one of each part, except you will need 4 wheels, 4 axle pegs, 4 linkage pegs, and 2 linkage arms. A windshield is not needed. I would advise not printing the hitch peg and hitch magnet--if you do print them, print the hitch magnet slightly larger, and the hitch peg slightly smaller.
*If printing an overall 75% scale model*:
Print axle pegs @ 90%
Print linkage pegs @ 60%
Print cow catcher @ 95%
Print everything else @ 75%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
