Thingiverse
Plug Spinner
por Phreak87
14
Descargas
5
Likes
0
Makes
this parts are needed to build your own plug spinner:
(if you picked a lock you can jump over the pin-line)
1. Print all parts
2. put the cylinder parts together (leave place for the spring)
3. put two springs inside the mechanism (this can be tricky)
4. take a lighter and melt the bolt
5. Press the melted part down with a metall so that the two rings can move freely.
6. Mount the key on the side with a M3 screw.
Now you can tighten the spinner until the lock is set and push the
button to release to start the spinning.
(if you picked a lock you can jump over the pin-line)
1. Print all parts
2. put the cylinder parts together (leave place for the spring)
3. put two springs inside the mechanism (this can be tricky)
4. take a lighter and melt the bolt
5. Press the melted part down with a metall so that the two rings can move freely.
6. Mount the key on the side with a M3 screw.
Now you can tighten the spinner until the lock is set and push the
button to release to start the spinning.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
