plug

Hi you all that have broken the trailer plug. Instead of throwing away the brass connectors with a 7mm outer diameter you can reuse them by printing an imitation of XT connector from PLA plastic.
Clean the oxidations with sandpaper and be sure to check all pair compatibility / tightness of the brass connectors - tighten by expanding the male part or loosen by squeezing it together.
example: the female hole is 5.6 or 5.5 mm >> drill larger 5.5 mm with a drill 5.6 mm is standard
Connector is very tight to open.
All is done with your own responsibility as with all diy projects.
3-pin modell, for brushless motor.
last version long no screw holes, cable joint tin , clean brass oxidation.
I loosen too tight connector , and stronger wall too..