Pocket box

Small pocket-sized box with rounded edges and button closure. Maximum opening 120º.

Instructions:

- Print the two halves with 0.4 mm or less of layer height. Being flat pieces of a certain size, it is necessary a good adhesion to the bed to avoid warping. The hairspray on the glass is not enough.

- Print the two pieces of the closing mechanism with 0.1 mm of layer height.

- Depending on the accuracy of the printer, it may be necessary to check the two parts of the closure, the hooks on the top and the hinges knuckles with a watchmaker file until everything fits and slides correctly.

- Glue the largest part of the lock into the corresponding hole in the bottom part box. If you have printed in ABS, use PVC cement.

- Once dry, place the spring and the opening button, and put a 0.6 mm diameter wire pin in the part of the button protruding into the inside of the box.

- Put a 0.7 mm diameter wire as a hinge pin.

-------

Se trata de una pequeña caja de tamaño bolsil