PolyDryer Wall Control/Pegboard Compatible Mount

Couldn't find any Wall Control compatible mounts for the PolyMaker PolyDryer so I remixed the original wall mount with three major changes:Adapted the screw holes to 1" spacing on the center to support standard pegboard hole pattern, anchored with the bottom most screw holeIncreased the screw hole diameter and countersink depth to match M5 flat head countersunk boltsDoubled the number of screw holes for maximum holding powah!You will need access to the rear of your Wall Control/pegboard to install this. I was unable to figure out a way to use Wall Control native hooks for this remix.Non-affiliate, direct, link to Amazon nuts and bolts I used in the pictures - https://www.amazon.com/gp/product/B073SVMX3T Thanks for checking it out and I hope it's helpful!