Polyend Tracker / Polyend Play Stand

A stand for the [Polyend Tracker](https://polyend.com/tracker/) and [Polyend Play](https://polyend.com/play/) consisting out of two side pieces that do fit it's casing nicely including recesses for the rubber feet. Still there's enough room on the back to not cover the power button and connectors. The sides can be equipped with some Polyend logo inlays if desired. The bottom side of the stands do offer notches for adding some self-adhesive foam tape up to 10mm width.

### Versions

The stand comes in multiple versions each using a different tilt angle from a 10° to 25° range to your liking - I personally do use the 15° version which is also the one shown in the pictures.

### Print settings

* print the stand with the logo facing down towards the build plate
* no supports needed
* if your printer has a good build plate adhesion you won't need a brim to prevent the parts from warping
* the bridge infill within the logos should print fine on a well calibrated printer
* the l