Thingiverse
Pool Bottle holder
von blubbermake
0
Downloads
1
Likes
0
Makes
Bottle holder for steel frame pool.
fits for frame diameter of about 37mm and bottle size of about up to 75mm.
depending on the water level in the pool, the height can be adjusted via thread.
Support is only needed for the part that fits to the pool frame (print this part upside down).
fits for frame diameter of about 37mm and bottle size of about up to 75mm.
depending on the water level in the pool, the height can be adjusted via thread.
Support is only needed for the part that fits to the pool frame (print this part upside down).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!