Pool hose holder

Made for 38mm hoses and clamping onto a 58mm round pool frame (such as most Intex and Bestway pools) If you need any other frame or hose dimension, give me a shout and I'll try and make it as soon as I have the time. The fit is nice and tight but I made holes for tie wraps to be sure (6mm*3mm square holes). The hose will stay in place and with a lot of clamping force, but a kid can easily rip it out when it thinks it's a toy. I use it for my heat pump, which is on a separate circuit than my filter and therefore the hoses need to hang in and out of the pool. This way I can be sure not to ruin my pump or heat pump because of the hose falling out. This also makes sure that the pump stays primed whenever I turn it off. This print needs A LOT of support. For maximum quality (and strength) use as little z-offset to the support interface layers as possible, but it will be a pain to clean up) I used 0,2mm offset and removing supports took easily 10 minutes with a decent knife and pliers Printi