Thingiverse
Pop-on Icecubes for ledstrings
von Wim_V
6
Downloads
10
Likes
0
Makes
Fast and easy print.
Nice to use in the tree or as table decoration as alternative to candles. Blue or white leds will be the most realistic. Beautifull refraction of the led lights viewing them from different angles.
For LEDs with diameter other than Ø4.5mm scale the basic model up or down. (you need to scale X, Y and Z simulatiously).
Print in PLA or PETG in vase mode and for maximum effect with clear filament..
Printing time about 2 min.
No support, USE Brim, nozzle 0.4, layer height 0.2.
To prevent breaking the tip when removing the brim, use minimum 3 bottomlayers.
Nice to use in the tree or as table decoration as alternative to candles. Blue or white leds will be the most realistic. Beautifull refraction of the led lights viewing them from different angles.
For LEDs with diameter other than Ø4.5mm scale the basic model up or down. (you need to scale X, Y and Z simulatiously).
Print in PLA or PETG in vase mode and for maximum effect with clear filament..
Printing time about 2 min.
No support, USE Brim, nozzle 0.4, layer height 0.2.
To prevent breaking the tip when removing the brim, use minimum 3 bottomlayers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
