Pop Socket Cap Collection

These four designs are meant to replace the cap of a pop socket. The four designs are inspired by [an apollonian gasket](https://en.wikipedia.org/wiki/Apollonian_gasket), a critical hit on a [d20](https://en.wikipedia.org/wiki/D20_System), the [smash bros logo](https://en.wikipedia.org/wiki/Super_Smash_Bros.), and the [colorado flag](https://en.wikipedia.org/wiki/Flag_of_Colorado).

They are all designed to be printed face down and without support material. The tabs are supported by bridges from supports within the model. I use 100% infill, but it shouldn't matter much which such small bodies anyway. Smaller layer height will give finer detail, but it should print alright at anything below 0.3 mm due to the bridging. I used 0.06 and it looks great.

Your print will probably look even better because I used what would be considered a low-end printer and the levelness of the bed could have been improved. I also think it would look better if the rest of the pop-socket was black so th