Thingiverse

Popsicle Maker

par Coolkid171717

2 Téléchargements

2 Likes

0 Makes

This is a Popsicle Maker that i made. It comes in two versions.

A thin one, which you will need the files
(1X) PopsicleMaker_Cups_STL.stl
(4X) PopsicleMaker_Stick1_STL.stl'
(4X) PopsicleMaker_Stick2_STL.stl

For the wide one you will need
(1X) PopsicleMaker_Cups(Wide)_STL.stl
(4X) PopsicleMaker_Stick1_STL.stl'
(4X) PopsicleMaker_Stick2(Wide)_STL.stl

To put it together you need to only slide the Stick2 files ontop of the Stick1 files. Then you superglue them in place.

To remove the popscicles after they have frozen overnight all you need to do is put hot water into a large bowl. Then immerse the cups into the bowl for about 30 seconds. If it does not come out, then immerse it in the water again.

The Wide popscicle maker is easier to remove the popsicles when they are done.

Another thing that has made the popsicles easier to remove was to spray the inside with Polyeurothane spray. You need to let it fully cure for a couple of days before using. Polyeurothane is foo

freezer frozen IceCream icecube icecubetray juice maker MakerBotDigitizer popsicle Popsicle Holder popsicle stick freezer frozen IceCream icecube icecubetray juice maker MakerBotDigitizer popsicle Popsicle Holder popsicle stick

Source

Thingiverse

Ce qu'il faut pour imprimer: Débutant Confiance faible

Monobloc

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 0/3

Imprimante

FDM / FFF

Format de fichier