Thingiverse
Potentiometer Support
door select1997
13
Downloads
22
Likes
0
Makes
First thingy so here goes ...
Couldn't find a support on here for the pot from a LM-2596 DC-DC for a benchtester and didn't want to wait on an ebay order so I gave it a shot.
Use a heated pin to make a starter hole as close to end of shaft as possible. Then use a lead from a 3mm LED in hole, cut with small amount extra and squeeze in with pliers.
Solder wires onto pot, place in holder (tight fit) and align shaft with adjuster.
Couldn't find a support on here for the pot from a LM-2596 DC-DC for a benchtester and didn't want to wait on an ebay order so I gave it a shot.
Use a heated pin to make a starter hole as close to end of shaft as possible. Then use a lead from a 3mm LED in hole, cut with small amount extra and squeeze in with pliers.
Solder wires onto pot, place in holder (tight fit) and align shaft with adjuster.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!