Potentiometer Volume Knob – 3D printable model from MakerWorld

MakerWorld

Electronics

Potentiometer Volume Knob

by ChunkAhoy · Electronics

262 Downloads

42 Likes

145 Makes

Go to Model

Summary This is a knob that will fit multiple potentiometers. See the picture to see what type it was modelled for. I needed this to replace a knob that wouldn't work with the replaced pot on an old set of Klipsch speakers i repaired a couple of years back. Enjoy! Print Settings Printer Brand: Creality Printer: CR-10 Rafts: No Supports: No Resolution: 0.2 to 0.1 Infill: 15% Filament: MG Chemical PLA Purple

amp amplifier audio audiophile diy klipsch knob part pot potentiometer potentiometerknob repair replacement speaker volume volumeknob

Category

Electronics

Source

MakerWorld

Published

22.08.2024

Updated

04.06.2026

What you need to print this: Beginner Low confidence

Why?

no supports

Support-free Single piece

Supports 0/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

PLA

Software

Cura, PrusaSlicer, or similar

Same designer, more platforms

ChunkAhoy also publishes on

16 additional models across 1 more platforms

♥ 4,506 ↓ 5,828 ⚒ 48

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee

DE EN FR ES IT NL