Thingiverse
Music
Go to Model
Samson Amp Mixer Knob
8
Downloads
7
Likes
0
Makes
Knob for a Samson Amplifier Mixer. I purchased a Samson mixer used and it was missing 3 knobs. This model is as close as I can get to the original knobs.
Print them Right side up with supports. A bit of cleanup on the bottom surface should let them slip right onto the potentiometer shafts.
If you found this design useful and feel inclined to contribute any amount, it would be greatly appreciated!
https://paypal.me/WTFRacing?country.x=US&locale.x=en_US
Print them Right side up with supports. A bit of cleanup on the bottom surface should let them slip right onto the potentiometer shafts.
If you found this design useful and feel inclined to contribute any amount, it would be greatly appreciated!
https://paypal.me/WTFRacing?country.x=US&locale.x=en_US
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
