Power Button Housing

LED Power Button Housing made to mount to 3d printers for relocating power button or for accessories. One version has rails to slide into the extruded rail slots and holes for Tnuts in the back to prevent it from sliding when pushing the button. 2nd version has holes for Tnuts only so that you can mount it without having to take anything off the printer in order to mount it.

To install the button in the housing drop the threaded washer in the slot with flat edges on the sides & one of the points facing down, thread the socket wires through the hole in the back and push the socket down out of the way. Screw the button in through the threaded washer all the way. Check the orientation of the power symbol if it matters to you & then push the socket onto the button's pins until the latch clicks into place. It is a tight fit to get the socket to click into place you will have to push on it after lining up the pins.

You may have to unscrew the button and rotate it before threading it ba