Thingiverse
Power Strip Support For Computer Table
von aasisodiya
0
Downloads
0
Likes
0
Makes
Power Strip Support For Computer Table
- Had to brake it in parts and then assemble it using superglue
- Tried Printing in one go but i was facing issues with my filament at the time
- Once Printed you will need 8 - 12 powerful magnets of 1cm diameter and 2mm thickness
- You can use "Magnet Support.stl" to test if the magnet can fit before printing the whole thing
- Will have to insert those magnets in the circular hole of the "Strip Support" and hammer them for tight fix.
- Then Super glue the Gripper and Gripper V2 (if needed) to the "Strip Support"
- Had to brake it in parts and then assemble it using superglue
- Tried Printing in one go but i was facing issues with my filament at the time
- Once Printed you will need 8 - 12 powerful magnets of 1cm diameter and 2mm thickness
- You can use "Magnet Support.stl" to test if the magnet can fit before printing the whole thing
- Will have to insert those magnets in the circular hole of the "Strip Support" and hammer them for tight fix.
- Then Super glue the Gripper and Gripper V2 (if needed) to the "Strip Support"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!