Thingiverse
Power Supply Bracket
von deathslayer10
20
Downloads
12
Likes
1
Makes
Wanted to find a way to mount my 30A flat pack ebay power supply. This bracket is designed to mount the power supply on the underside of the Reprap Prusa printer.
The bracket is made parametric to allow easy adaptation if you do not have right length screw.
NOTE: The STL file provided is 32mm wide from the rod to the power supply. May not fit for some printers.
The bracket is made parametric to allow easy adaptation if you do not have right length screw.
NOTE: The STL file provided is 32mm wide from the rod to the power supply. May not fit for some printers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
