Slicer Discord
powerful sugar rocket – 3D-Druckmodell von MakerWorld MakerWorld
Sport & Outdoors

powerful sugar rocket

10 Downloads
8 Likes
0 Makes
Zum Modell
a sugar rocket requires a launch rod 10 mm or smaller flies about 300m fully packed. also i use a 65 35 ratio of 65 potassium nitrate and 35 sugarto use: put rocket fuel in the back BEFORE putting the nose cone on then pack the rocket fuel repeat 2-3 times till about 2cm and then get the nozzle put super glue ALL over the outside and put it in with the LONG side facing in so the short side is on the outside of the rocket. - if the nozzle is a tight fit tilt it on a 45 degree angle put it in then grab a hammer and hit it till it moves and becomes flat put the top on then put the fuse or sparkler in the bottom, slide the rocket down light it and RUN this could explode so go far and watch it woosh. (by the way it would be nice if you commented that it worked for you and if not i can change the design)
Kategorie
Sport & Outdoors
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen