Thingiverse
Precision Piezo Hypercube Bed Mount
von TURNERO
1
Downloads
1
Likes
0
Makes
This is a remix of the precision piezo mounts for the HEVO. It'll probably work for most printers. The bed mounts rigidly to the lid with a short M3 screw and nut.
The bed levelling screws go into the sensor body with a flat head M3 screw. If it's not flat head then I think it will stick up into the piezo disk.
You'll need 4 for a regular bed.
I haven't tried these yet.
The bed levelling screws go into the sensor body with a flat head M3 screw. If it's not flat head then I think it will stick up into the piezo disk.
You'll need 4 for a regular bed.
I haven't tried these yet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
