Thingiverse
Presentation Stand
par seabirdhh
27
Téléchargements
17
Likes
0
Makes
If you are looking for a presentation stand for a special object ... this one might be it!. The different 3D models shown in the video https://youtu.be/QlIysXrMD04 give you an impression how it could look like. Of course the possibilities of 3D printing are not as manifold as shown in the video.
The plate is held in position by 4 nylon threads (Ø 0,35mm).
Dimensions: L200 x H158 x W160mm. Base Ø 80mm, plate Ø 105mm.
Start by gluing the large bow into the base. I used superglue. A small bulge in the middle of the bow will help you with the alignment.
Then you can insert the small bow. I used a screwdriver to press it into place. To ensure a good fit, the fitting accuracy is very tight. It may be necessary to correct the fit with a cutter knife or sandpaper.
Now prepare 4 nylon threads with approx. 20-25cm length. Insert them into the holes of the plate. A multiple knot is enough to fix the thread to the plate. Then start by hanging the plate into the big bow. The thread
The plate is held in position by 4 nylon threads (Ø 0,35mm).
Dimensions: L200 x H158 x W160mm. Base Ø 80mm, plate Ø 105mm.
Start by gluing the large bow into the base. I used superglue. A small bulge in the middle of the bow will help you with the alignment.
Then you can insert the small bow. I used a screwdriver to press it into place. To ensure a good fit, the fitting accuracy is very tight. It may be necessary to correct the fit with a cutter knife or sandpaper.
Now prepare 4 nylon threads with approx. 20-25cm length. Insert them into the holes of the plate. A multiple knot is enough to fix the thread to the plate. Then start by hanging the plate into the big bow. The thread
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
