Pride Flag Hooks

**__Ko-Fi:__** [https://ko-fi.com/juliettaexpress](https://ko-fi.com/juliettaexpress)

---

3D printable hooks for pride flags that look rather... hmm... Fully parametric -- if the angle or the size are too large for your holes, it's as easy as editing the numbers in Fusion360, then right-clicking the relevant ready body and clicking "Save as Mesh". These fit most ring-based pride flags. The included STL's are pre-emptively sized for GRK 114069 screws that I abuse *everywhere*.

Please note, these are not, and should never be, load bearing. Layer separation is ALWAYS the weakest point of an FDM print, and the layers are *directly* on the shear line with this design. Hanging is fine, but don't pull on it or anything.

**Print with 200 shells top/bottom**. Yes I'm serious, make **every** layer a shell, with 2 perimeters. slicers might get weird with 100% infill, but they seem to do *really* well with making every single layer a shell. Is it necessary? Maybe not, idk, it certainly