Thingiverse
Printable Kill Zone
door Ambroglio
1
Downloads
1
Likes
0
Makes
A printable full-sized 22"x30" Kill Zone with an inset grid, magnetic attachments, and numbered panels for easy assembly
Something I threw together while setting up a virtual environment for testing out terrain builds. I haven't done a test print, and probably never will, but I know this was the kind of thing I was looking for early in getting my kit together so I decided to share it
These prints do require support for the insets and numbers, but it's a very small amount compared to the total area
Assembly requires 136 5mm x 1mm round magnets which are all glued into place. At 10% infill and 0.8mm surfaces, it should take just over 1kg of PLA, so if you play around with your printer settings and thin up the walls, tops, and bottoms you can get it just below
The largest panels are 210.5mm x 210.5mm so they should just barely fit on a standard Ender 3 build plate
Something I threw together while setting up a virtual environment for testing out terrain builds. I haven't done a test print, and probably never will, but I know this was the kind of thing I was looking for early in getting my kit together so I decided to share it
These prints do require support for the insets and numbers, but it's a very small amount compared to the total area
Assembly requires 136 5mm x 1mm round magnets which are all glued into place. At 10% infill and 0.8mm surfaces, it should take just over 1kg of PLA, so if you play around with your printer settings and thin up the walls, tops, and bottoms you can get it just below
The largest panels are 210.5mm x 210.5mm so they should just barely fit on a standard Ender 3 build plate
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
