Thingiverse
Printer A-frame spool thing.
door eddiema
7
Downloads
9
Likes
0
Makes
A kit of parts to join tubes to make an A-frame.
Mine is made from fibreglass tent poles which are a bit under 13mm in diameter. These just happened to be on special at $4au for a set of four (plus other bits).
Otherwise I would have used 16mm curtain rod (which is tube actually).
It should be possible to re-scale the parts for other sizes.
My printrbot sits in a bamboo serving tray which has inside dimensions of 300*475mm.
The poles are 700mm long so the angle at the apex comes out close to 24 deg.
The parts are over engineered and are overkill to support a few kilos of plastic.
I have left some early versions of parts in the SU file.
Mine is made from fibreglass tent poles which are a bit under 13mm in diameter. These just happened to be on special at $4au for a set of four (plus other bits).
Otherwise I would have used 16mm curtain rod (which is tube actually).
It should be possible to re-scale the parts for other sizes.
My printrbot sits in a bamboo serving tray which has inside dimensions of 300*475mm.
The poles are 700mm long so the angle at the apex comes out close to 24 deg.
The parts are over engineered and are overkill to support a few kilos of plastic.
I have left some early versions of parts in the SU file.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!