Thingiverse
Printer Bed Puller
door Pugwash
30
Downloads
17
Likes
0
Makes
Finger-sized bed puller for your printer bed. Simple design using little material so quick to print. Much simpler than a handle but stops you touching the hot bed.
If you are using a heat-resistant material you could mount this above the spring. The design is shaped to allow this, but in PLA it would soften and droop, so mine is fitted below the spring.
If you are using a heat-resistant material you could mount this above the spring. The design is shaped to allow this, but in PLA it would soften and droop, so mine is fitted below the spring.
Pugwash publiceert ook op
83 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
