Thingiverse
PRINTER BED STAND
von chasgiv4
6
Downloads
8
Likes
1
Makes
https://www.facebook.com/groups/1156304777857840/
Original design was a little too small. I was told it was falling over so I widened by 40mm and lengthened the rear by 55mm and added a place to hold parts.
Just a quick design someone asked me to make.
4MM slots at 80 degree angle.
Happy Printing.
Original design was a little too small. I was told it was falling over so I widened by 40mm and lengthened the rear by 55mm and added a place to hold parts.
Just a quick design someone asked me to make.
4MM slots at 80 degree angle.
Happy Printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
