Thingiverse
Printer Calibration Tool
von Enginethrust
26
Downloads
9
Likes
1
Makes
Small tool to help fine-tuning bed level and axis position.
Be very careful when positioning the axis on top of the tool, use the minimal amount of jog movement when controlling the z-axis and manual positioning by hand (if allowed) to move print bed and extruder in the y-axis and z-axis to avoid collision and damage.
First use the tool to ensure the x-axis is on a parallel plane above the y-axis. Move the x-axis close to the tool. Turn the threaded rods by hand until to tool touches the x-axis on both y-axis the same way.
Next the build plate can be leveled in the same manner by adjusting the screws on the print bed. Slide the tool along the x-axis (as seen in the pictures) for different y positions of the bed to ensure the bed is parallel to the x-axis.
You can use the plane surface or the cutout of the tool for calibration as seen in the pictures. If there is an endstop near one y-axis, preventing the tool to fit with the cutout, use the plane section of the tool for the
Be very careful when positioning the axis on top of the tool, use the minimal amount of jog movement when controlling the z-axis and manual positioning by hand (if allowed) to move print bed and extruder in the y-axis and z-axis to avoid collision and damage.
First use the tool to ensure the x-axis is on a parallel plane above the y-axis. Move the x-axis close to the tool. Turn the threaded rods by hand until to tool touches the x-axis on both y-axis the same way.
Next the build plate can be leveled in the same manner by adjusting the screws on the print bed. Slide the tool along the x-axis (as seen in the pictures) for different y positions of the bed to ensure the bed is parallel to the x-axis.
You can use the plane surface or the cutout of the tool for calibration as seen in the pictures. If there is an endstop near one y-axis, preventing the tool to fit with the cutout, use the plane section of the tool for the
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
