Thingiverse
PrinterMods Xchange Alignment Pin
por bversluis
7
Descargas
5
Likes
0
Makes
Alignment pin for the PrinterMods Xchange. Intended as a replacement, just as fragile as the original.
Designed to be printed with a resin printer, 0.05 mm layer height. Supports probably needed (see chitubox image or file for orientation).
If you brake a pin and the threaded part is left behind in the Xchange tool plate, just use a small drill to drill out the largest part and than use a M5 screw from the other side to completely remove the remains from the hole.
Designed to be printed with a resin printer, 0.05 mm layer height. Supports probably needed (see chitubox image or file for orientation).
If you brake a pin and the threaded part is left behind in the Xchange tool plate, just use a small drill to drill out the largest part and than use a M5 screw from the other side to completely remove the remains from the hole.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
