Printrbot Simple (2014) - Leds Mount

Simple mount for 3 Leds (5mm). I tried to provide an angle so Leds actually converge.

For me this works great. I normally print at night and my studio is not that well iluminated.

It is very simple to be mounted, basically use the same hook for the tie zip that wraps the cables for the hotend.

Electrical installation: I didn't want to mess (at all) with the electricity of the printer. So I basically hooked this up to another transformer I had laying around. This only draws ~50mA, so I *think* it could be connected to a port in the motherboard. Not worth the risk for me.

Note: the green led is just because I ran out of whites ;).