Thingiverse
Propane Cap
door winklmj
107
Downloads
73
Likes
2
Makes
Cap for the typical 1lb throw-away/disposable propane/mapp gas tanks that have a 1" x 20TPI thread. Keeps partially used tanks from slowly leaking out when the valve sticks open. You'll need to supply a rubber gasket to use with the cap.
(FYI, Added a PropaneCap-mm.stl file because Cura didn't like the original which was exported in inches instead of mm).
(FYI, Added a PropaneCap-mm.stl file because Cura didn't like the original which was exported in inches instead of mm).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
