Thingiverse
Propeller Driven Car
door Petal3D
6
Downloads
8
Likes
0
Makes
The Propeller Driven Car is a vehicle that is moved by a propeller. Models for the Platform and various Motor Mount options are included. The Motor Mount is designed to hold a small DC motor, to which is attached a propeller. The size of the motor is approximately 20mm diameter and 15mm across the main flats.
For the Motor Mount, ideally select the v06 model with a suitable amount of design clearance. Select an option based on the capability of your available 3D printer. If unsure, start with the model with 0.4mm clearance.
0.2mm - no dot - resin printer
0.4mm - one dot
0.8mm - two dots
1.2mm - three dots
An older v05 version of the Motor Mount is also included.
Supports are not required. For a filament printer, use 25% infill and 2 shells.
If the motor has a loose fit, use double-sided tape, a suitable adhesive (epoxy) or a cable tie. Attach the Motor Mount to your platform using double-sided tape.
The models may be used for a propeller driven car PROPC, which is a
For the Motor Mount, ideally select the v06 model with a suitable amount of design clearance. Select an option based on the capability of your available 3D printer. If unsure, start with the model with 0.4mm clearance.
0.2mm - no dot - resin printer
0.4mm - one dot
0.8mm - two dots
1.2mm - three dots
An older v05 version of the Motor Mount is also included.
Supports are not required. For a filament printer, use 25% infill and 2 shells.
If the motor has a loose fit, use double-sided tape, a suitable adhesive (epoxy) or a cable tie. Attach the Motor Mount to your platform using double-sided tape.
The models may be used for a propeller driven car PROPC, which is a
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
