Propeller Plane

I wanted a little decoration for the exhaust fan from some laser cutters so I designed this little plane inside of fusion. This is not a wind vane and not meant to turn to show the direction of the wind. All pieces should be snap fit however I would recommend gluing the pieces in if it will see considerable gust(especially the back pieces which will not stay in).

To make the propeller spin, I used the bearing linked below which is inserted into the box hub.

https://www.printables.com/en/model/874638-print-in-place-6200-ball-bearing

I designed a small holder for the plan in which I stuck an 0.85in plastic pipe to hold it up. There is also a version of the plane fuselage where the pipe can directly be stuck into the plane fuselage itself if you so wish.