Thingiverse
ProtoscopE
door caseyjholmes
11
Downloads
10
Likes
0
Makes
A eurorack mounted Xprotolab oscilloscope module panel.
You'll need to somehow obtain a discontinued Xprotolab module from Gabotronics.com to build one. You'll also need some strip board, a 5v regulator, two capacitors for the regulator, an LED, a 220ohm resistor for the LED coming off the 5V regulator (to indicate the module 5v output is working properly), four Thonkiconn mono 3.5mm audio jacks and a vertical PCB mounted potentiometer (like alpha(s)) to use for an attenuator to hook up to channel 2 input, just for fun. The outputs are simply "multed" inputs to pass through the signal to other modules in the signal chain. I threw in a D shaft knob file. Print this with TPU so it slip fits the D shaft potentiometers. The panel can be printed with PLA. It's flimsy at first, until the whole module is assembled and soldered/screwed together, but solid when completed.
The panel is one hair wider than a normal 8HP panel but if you scoot your other panels to the left and right, it sho
You'll need to somehow obtain a discontinued Xprotolab module from Gabotronics.com to build one. You'll also need some strip board, a 5v regulator, two capacitors for the regulator, an LED, a 220ohm resistor for the LED coming off the 5V regulator (to indicate the module 5v output is working properly), four Thonkiconn mono 3.5mm audio jacks and a vertical PCB mounted potentiometer (like alpha(s)) to use for an attenuator to hook up to channel 2 input, just for fun. The outputs are simply "multed" inputs to pass through the signal to other modules in the signal chain. I threw in a D shaft knob file. Print this with TPU so it slip fits the D shaft potentiometers. The panel can be printed with PLA. It's flimsy at first, until the whole module is assembled and soldered/screwed together, but solid when completed.
The panel is one hair wider than a normal 8HP panel but if you scoot your other panels to the left and right, it sho
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
