Thingiverse
Protractor
por smorgana
14
Descargas
11
Likes
0
Makes
A six inch protractor. Will be accurate if your printer is accurate.
To measure angles, align the inside straight edge with the bottom side of the angle, with vertex at center line of the rule..
Angles are marked every 10 degrees with 45 degrees marked also.
bottom edge serves as a straight edge, and 6 inch rule.
I made this as my first project in FreeCAD...
To measure angles, align the inside straight edge with the bottom side of the angle, with vertex at center line of the rule..
Angles are marked every 10 degrees with 45 degrees marked also.
bottom edge serves as a straight edge, and 6 inch rule.
I made this as my first project in FreeCAD...
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!