Thingiverse
Protractor
door smorgana
14
Downloads
11
Likes
0
Makes
A six inch protractor. Will be accurate if your printer is accurate.
To measure angles, align the inside straight edge with the bottom side of the angle, with vertex at center line of the rule..
Angles are marked every 10 degrees with 45 degrees marked also.
bottom edge serves as a straight edge, and 6 inch rule.
I made this as my first project in FreeCAD...
To measure angles, align the inside straight edge with the bottom side of the angle, with vertex at center line of the rule..
Angles are marked every 10 degrees with 45 degrees marked also.
bottom edge serves as a straight edge, and 6 inch rule.
I made this as my first project in FreeCAD...
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!