Thingiverse
Learning
Ver Modelo
protractor
42
Descargas
78
Likes
0
Makes
I made a protractor, It can draw circles 、angles and measuring angle.
special tips:
When it's finished printing,it might be a little tight.
let it takes a few more turns.
This model was printed using PLA. (fill in 10~15%，using a lower layer hight (0.15~0.2mm)，no support)
special tips:
When it's finished printing,it might be a little tight.
let it takes a few more turns.
This model was printed using PLA. (fill in 10~15%，using a lower layer hight (0.15~0.2mm)，no support)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
