Thingiverse
protractor with alignment arm
por WHT_N_TH_WRLD
0
Descargas
0
Likes
0
Makes
fillament: petg
printer: prusa mk4s
I used 0.10mm detail for the shaft and c-clips, but 0.20mm detail for the protractor and arm. It seemed to work fine.
15% infill
The tolerences are a bit tight, so you may have to adjust.
The part of the shaft for the c-clips is 4.5mm in diameter and 2mm tall.
You just need one of everything exept for the c-clip. You need two c-clips.
All you have to do is align the arm with one angle, and the protractor with another angle. the slots in the arm let you see the angle of the protractor.
printer: prusa mk4s
I used 0.10mm detail for the shaft and c-clips, but 0.20mm detail for the protractor and arm. It seemed to work fine.
15% infill
The tolerences are a bit tight, so you may have to adjust.
The part of the shaft for the c-clips is 4.5mm in diameter and 2mm tall.
You just need one of everything exept for the c-clip. You need two c-clips.
All you have to do is align the arm with one angle, and the protractor with another angle. the slots in the arm let you see the angle of the protractor.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
