Thingiverse
PRS Guitar Toggle Switch Tip
por doylezdead
16
Descargas
10
Likes
0
Makes
Tip/Cap to fit Paul-Reed-Smith guitars' pickup toggle switches.
It's not an exact replica, just an approximation since I didn't have the original or very good reference for that matter.
The slot has a little tolerance baked into it for the printer (0.4 mm each way). For my printer this ends up being very close. For a tight fit, I'd recommend cutting pieces of 7x4.5mm paper to shim into the slot.
It's not an exact replica, just an approximation since I didn't have the original or very good reference for that matter.
The slot has a little tolerance baked into it for the printer (0.4 mm each way). For my printer this ends up being very close. For a tight fit, I'd recommend cutting pieces of 7x4.5mm paper to shim into the slot.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!