Thingiverse
Prusa LED Holder
by Hobb3s
43
Downloads
21
Likes
0
Makes
I really liked the idea of a light in my enclosure that wasn't attached to the enclosure so that quick and easy removal of the enclosure for maintenance wasn't a hassle.
I found this one which I liked and printed, then realized the issues with it; scaling and the extruder would hit it at full height. I used it as a basis to create my own and add height to it.
After printing the LED strip holder needs to be glued together. I just used some leftover 12v LED tape strip that I had from a different project. I wired it into a spare 12v output on my power supply and control the light with a relay switch that is controlled through GPIO output via Octoprint on a raspberry pi.
***update***
I added some new fasteners to attach it to the ceiling of the enclosure and ditched the arms. New stl added for the fasteners.
I found this one which I liked and printed, then realized the issues with it; scaling and the extruder would hit it at full height. I used it as a basis to create my own and add height to it.
After printing the LED strip holder needs to be glued together. I just used some leftover 12v LED tape strip that I had from a different project. I wired it into a spare 12v output on my power supply and control the light with a relay switch that is controlled through GPIO output via Octoprint on a raspberry pi.
***update***
I added some new fasteners to attach it to the ceiling of the enclosure and ditched the arms. New stl added for the fasteners.
Hobb3s also publishes on
51 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
