Thingiverse
Gadgets
Zum Modell
PS3 Controller Stand/Cradle
380
Downloads
421
Likes
12
Makes
Stand for a PS3 controller.
Printed with 1.75mm high temp ABS at 25% fill.
Two base options. Original extends about 15mm beyond the edge of the controller. Narrow is about 10mm within the edge. I prefer the narrow.
Printed with 1.75mm high temp ABS at 25% fill.
Two base options. Original extends about 15mm beyond the edge of the controller. Narrow is about 10mm within the edge. I prefer the narrow.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
