PS4 controller (dualshock 4) octagonal gate

Remixed from Vulcan2405's Xbox Elite Octagonal Gate (V2)

i was searching for one but there were none so i made one

this has no teeth because surprisingly i found out by inserting it the wrong way that it snaps onto the analog even without teeths. i find this also better because those teeths tends to snap

i made 4 versions, a very thick one which is 2.5mm of height, a thick one (2mm), a medium one (1.5mm) and a thin one (1mm)

i recommend to use 1mm resolution and the slowest speed (like 10ms for perimeters and external perimeters), since you want the most quality out of this because its small, and those 30 seconds more of printing aint gonna do much to u, so if you dont want this to go into pieces use the best settings you can put.
i also found myself better with PETG rather then PLA, pla would break more easily for some reason.